FOWLER & MARSHALL
Traction Engine Parts
Various traction engine spares available, as per the above photo.
Parts include: eccentric straps, valve gear con rods, regulator and gear chance parts,
various bronze bearings and bearing caps, boiler clack valve fittings, etc, etc. |
|
 FOWLER
Tow Hitch Coupling
Complete unit in cast steel.
Suitable for a traction engine over abt 6 NHP.
|
|
 FOWLER
Traction Engine Parts
1x cast differential bevel gear/axle remains.
1x Fowler nearside wheel locking hub/axle remains.
Both suitable for approx 8 NHP traction engine.
|
|
 FODEN
Traction Engine
Trunk Guide
Cross-head trunk guide in cast iron.
From a Foden traction engine.
|
|
 RANSOMES,
SIMS & JEFFERIES
Traction Engine Cylinder Block
7/8 NHP Single Cylinder
Cylinder block and various parts including piston
and crosshead, safety valve assembly, etc. |
|
 RANSOMES,
SIMS & JEFFERIES
Portable Engine Cylinder Block
8 NHP Single Cylinder
Cylinder block and various parts including piston
and crosshead, valve assembly and guide, etc. |
|
 FOWLER
Traction Engine
Cast Motion Bracket
(Carries cross head slides and reversing gear, etc).
Suitable for approx 6 NHP traction engine.
|
|
 FOWLER
Traction Engine
Winding Drum
Winch winding drum for approx 8 NHP Fowler.
(Mounts behind the nearside rear wheel).
|
|
 MARSHALL
Traction Engine
Steering Brackets
Pair of brackets for holding steering gear and shaft.
Suitable for a 6 or 7 HP traction engine.
|
|
 BURRELL
Traction Engine
Rear Wheels
1x two pin drive 6 Ft 6" dia Burrell rear wheel.
2x (pair) single pin 6 Ft 6" dia Burrell rear wheels.
Suitable for 6+HP traction engines.
In good original condition.
|
|
 FOWLER
Traction Engine
Rear Wheels
2x single pin drive 5 Ft 5" dia Fowler rear wheels.
Suitable for a circa 5+HP traction engine.
In good condition.
|
|
 CLAYTON & SHUTTLEWORTH
Traction Engine
Rear Wheels
2x two pin drive 6 Ft dia Clayton rear wheels.
Suitable for a circa 5 to 8 HP traction engine.
In good condition.
|
|
 CLAYTON & SHUTTLEWORTH
Traction Engine/Steam Tractor
Rear Wheels
Single pin drive 5 Ft 5" dia Clayton rear wheels.
Suitable for a circa 4 to 6 HP steam tractor or traction engine.
In good condition.
|
|
|
|
